You must have javascript enabled to use light-bulbs.biz !

Climate Control Light Bulb Repair Kit for 05-07 Chrysler Town & Country

Minivan

USD $11.95

Condition : New

Free Shipping

{{variant_type_name}} :
eBay
SKU: N/A This site contains affiliate links for which we may be compensated eBay Motors / Parts & Accessories / Car & Truck Parts & Accessories / Air Conditioning & Heating / HVAC Controls & Control Units

Notify me when the price drops

We will email you if we find a lower price on this product!

Target price (USD) $
This is a kit of 5 lamps (light bulbs) to repair your 2005, 2006, or 2007 Chrysler Town & Country Automatic, Dual Zone, Climate Control
head unit. Fits the AUTOMATIC, DUAL ZONE, temperature control pictured. It might fit the manual versions, but I can't verify.
IMPORTANT: installation requires soldering
. These lamps are soldered to the circuit board, so you must use a low wattage, fine tipped, soldering iron to make this repair. See photos.
These five T-1 size incandescent lamps provide the backlighting for the climate control panel. The temperature indicator (blue digital display) and yellow/amber knob position indicators (LEDs) are not included in this kit.
You will receive 5 incandescent lamps with bi-pin bases. They are exact fit, T-1 14V 40mA, but must be soldered on to the circuit board
. I strongly recommend replacing all 5 bulbs while you have the control open. These lamps fit:
  • 2005-2007 Chrysler Town & Country

  • If your climate control looks like mine (2005, pictured), these lamps will fit. This is the automatic, dual-zone (front & rear) climate control, typically found in the higher trim models.
    The replacement job is 30-60 minutes, but you must
    be experienced with soldering.
    How to install:
    You'll need a Phillips screwdriver, T-10 and T-15 Torx drivers, plus soldering equipment.
  • Remove the cupholder by pressing the release in the center rear top (toward the front of the van).
  • Remove the trim strip just above the cupholder.
  • Remove the two center screws (on the black plastic); leave the outer screws alone.
  • Pull the entire radio frame loose--it's held in place with 4-6 clips--start at the bottom and work up along the sides.
  • Unplug the 4 connectors, 2 in the rear wiper/seat heater control, 2 from the climate control. The small 2-pin plug uses an obvious latch. For the 3 larger connectors, slide the red locks back (away from unit, towards wire), then squeeze just behind that red piece to unlatch. Once unlatched, they unplug easily.
  • The entire radio frame should now be free of the vehicle--take it inside to a table.
  • Unplug the black plug from the end rear of the climate control unit.
  • Remove the 6 screws (T-10) holding the climate control to the frame (somewhat optional--I think you could skip this step).
  • Carefully pull off the 3 knobs on the front of the climate control unit. Use strong fingers only.
  • Remove the 4 screws (T-15) holding the back on the climate control unit.
  • KEEP UNIT FACE DOWN and lift the back off (face up and all the button actuators will fall out).
  • Unplug the connector, remove the screw from the center of the PC board, then remove the PC board.
  • Unsolder the 5 lamps and replace with the new ones from my kit. I believe the PCB uses RoHS solder--I had to use the 850° setting on my soldering iron.
  • Reverse the above steps to reassemble.
  • Returns Accepted for this item if it's within 30 Days

    Climate Control Light Bulb Repair Kit for 05-07 Chrysler Town & Country Minivan
    blinking brake light bulb | trailblazer fog light bulb | amber light bulbs for sleep | ford ranger dome light bulb | sewing machine light bulbs
    See more
    Price type
    IN STOCK OUT STOCK